Star wars acclamator class assault ship generator#
Star wars acclamator class assault ship torrent#
Star wars acclamator class assault ship windows#

Panels, with most operators being seated in twin crew pits below the command officer's area. The bridge crew usually consisted of fully-armored clone pilots manning the control Holoscreens shaped like the triangular viewports similar to the ones on other Kuat

Star wars acclamator class assault ship windows#

The main bridge and command center had no windows but relied upon advanced This tower module was a standard design for smaller ships in Kuat Drive Yards's starship catalog, which Rothana supplied vessels to. The bridge was located in the middle of an arrow-shaped command tower module that protruded from the dorsal superstructure. When landed, the repulsorlift carried much of the ship's weight, but the landing legs maintained a stable contact with the ground.

Star wars acclamator class assault ship generator#

The massive fin at the stern of the Acclamator-class contained both the anti-gravity generator and the ship's hyperdrive generator. The secondary thrusters did not provide as much power, but were useful for maneuvering due to being placed further away from the ship's main The ship's main thrusters were fitted with eight electromagnetic rudders that deflected the exhaust particle streams and gave boost when turning the ship. Secondary reactors were located towards the bow of the vessel. The tanks were connected to the main reactor via pipe assemblies. The tanks compressed hypermatter to enormous density for storage. The Acclamator-class's main reactor was located in the middle of the vessel, inside the main superstructure, and was preceded at the frontal half of the ship by multiple fuel tanks. Most of the passenger and barrack decks were located on the upper levels of an The two levels were connected with elevator platforms. A lower, smaller hangar area was used to embark and disembark ground troops and material when landed. Gunships were suspended along an overhead circulating rail in the upper hangar for maintenance procedures during travels. Eighty LAAT gunships were carried to insert personnel, vehicles, and cargo into battle zones in addition to providing close air Fusion rockets fired by enemy forces barely made a scratch on the hull as aДЄcclamator I-class ships also carried support equipment and vehicles, such as the AT-TE and SPHA-T walkers, used to provide clone troopers with heavy battlefield support.Д®ach Acclamator I-class ship held 320 speeder bikes, used by clone troopers for fast battlefield reconnaissance and patrol duties. The hull armor of Acclamator-class vessels was impregnated with ultra-dispersive neutronium that withstood and spread massive energy blasts. The sensor and communications suites were located at the front of the ship's command In addition to ground landings,ДЄcclamator-class ships were capable of water landings, as displayed at the Battle of Mon The later Acclamator II-class could also serve as star frigates to support their landing groups. Groups of these ships could perform a 'Base Delta Zero', an orbital bombardment that would exterminate all life on the These ships were armed with 4 heavy torpedo launch tubes 24 point-defense laser cannons, rated at 6 megatons per shot and 12 quad turbolaser turrets, each rated at a maximum of 200 gigatons per shot. This basic design was used in a number of larger craft predating it and would define Imperial ships for decades to come. TheДЄcclamator I favored a wedge or dagger shaped design, like the Republic warships during the Mandalorian Wars, due to its effectiveness-it allowed concentration of firepower while minimizing target profile. The 752-meter-long Acclamator I-class assault transport carried thousands of Republic clone troopers into battle.

Star wars acclamator class assault ship torrent#

Rothana Heavy Engineering's Acclamator Star DestroyerДЎ56 V-19 Torrent Starfighters (In Fighter Carrier Star Wars-Capital Ships- Acclamator Star Destroyer at Galactic Voyage